It is designed to ensure the safety of stationary objects (airports, railway stations, stadiums, subways, etc.) in conditions of possible terrorist attacks using explosive devices.
The device operates by creating special radio signals in the frequency ranges used in industrial and homemade radio fuses. The device reliably prevents the operation (blocks) of radio fuses from the coded radio signal transmitted by the command device.
The base units, as well as the antennas of the device, are located inside the building or outside it. The number of base units required to ensure the safety of the facility is determined based on its area (volume) and configuration. The control panel of the device is located in a room convenient for the user. The device is powered by an alternating current network of 220 V 50 Hz.
The device provides suppression of radio fuses in the frequency range of 20 ... 2700 MHz and has a continuous spectrum.
The device has a built-in automatic diagnostic system. In case of an emergency, the sound and light alarm signal is output to the control panel. If the antenna cables are broken or the antennas are damaged, they are switched off automatically to prevent the corresponding amplifier units from failing.
Stationary broadband radio fuse jammer External power supply from 220V 50Hz AC network Built-in digital diagnostic system with fault signaling Continuous spectrum Only two ultra-wideband antennas provide radiation in the entire frequency range The total output power is measured at a load of 50 Ohm.