It is designed to ensure the safety of VIPs, to protect convoys, police and combat vehicles in the event of a threat of terrorist attacks against them using explosive devices with radio fuses.
The device reliably prevents the activation (blocking) of radio fuses from a coded radio signal transmitted by the command device in the frequency range of 20...2700 MHz.
It is manufactured in a single housing and is placed inside the vehicle. It is powered from the on-board network of 12 V, 24 V or 27 V. The device is controlled using a wired remote control, a laptop-type computer or a combat information and control system of a combat vehicle. A set of antennas is placed on the roof of the vehicle on removable magnetic bases.
Thanks to the use of OptiJam technology, the emitted signal of the device has a high spectral density, which significantly increases the radius of suppression of radio fuses, while maintaining a safe level of radio emission for personnel.
The device has a fully digital control, which ensures switching on/off of the entire device and individual letters of the sub-ranges, the formation of communication windows. All switching is carried out using electronic keys (without electromechanical relays). The device status is displayed on the control computer display, the combat information and control system, or on the control panel.
The device has a built-in automatic diagnostic system that monitors the operability of all units and blocks. In the event of an emergency, an audible and visual alarm signal is output to the control panel, computer, or combat information and control system indicating the faulty unit or block. If the antenna cables are broken or the antennas are damaged, they are switched off automatically to prevent the failure of the corresponding amplifier units.
transport broadband jammer of radio fuses use of OptiJam technology power supply from a standard vehicle on-board network built-in digital diagnostic system with a malfunction alarm digital control design meets military standards Total output power is measured at a load of 50 Ohm.