Power supply and control units "Sonata-IP4.1" and "Sonata-IP4.2".
Power supply and control units "Sonata-IP4.1" and "Sonata-IP4.2" are intended for:
1) power supply and control of elements of the active acoustic and vibration protection system of acoustic speech information "Sonata-AV" model 4B (System) connected to the "Load" output during its operation;
2) control of means of active protection of information from leakage due to PEMIN ("Sonata-R3", "Sonata-R3.1", "Sonata-RS3"), connected to the "Load" output;
3) automatic monitoring of the serviceability and operating modes of devices connected to it;
4) settings (integral level settings, spectrum corrections, etc.) of the products listed in paragraphs 1 and 2, and reading service information from them (operating time counter status, error code in case of failure, individual address, etc.) during installation (checking) of the complex of technical means of information protection.
To perform paragraphs 3 and 4. the products "Sonata-IP4.1" and "Sonata-IP4.2" must be connected to the control PC.
Devices that do not have a ReBus-3 interface can be connected to the System via the interface units "Sonata-SK4.1" and "Sonata-SK4.2".
The power supply and control units "Sonata-IP4.1" and "Sonata-IP4.2" are part of the "Sonata-AV4B" System and are certified as part of it.
Main technical characteristics
Parameter
Value
"Sonata-IP4.1"
"Sonata-IP4.2"
Number of "physical" outputs for connecting loads
1
Number of "logically" controlled devices, pcs., not less than
239
Output voltage, V
12.5 ± 0.5
Interface/protocol for controlling devices connected to the "Load" output
ReBus-3 (3-wire)
Load capacity*), mA, not less than
1500
Power consumed from the network, W, not more than
40
Power supply
network ~220V/50Hz
Types of indication (displayed information)
light, sound
Interface for connecting to a control PC
USB 2.0
Remote interface monitoring
No
Ethernet 10/100BaseT, RJ45, TCP/IPv4,
static IP, DHCP client
Software for configuring devices connected to the "Load" output